Drills useable by both small and large hydraulic systems

For jobsite versatility, General Equipment Company’s DIG-R-TACH line allows for use with both small and large hydraulic systems. Featuring a two-speed chain/sprocket drive and a 5 to 20 gpm hydraulic flow range, the Series 16 balances smaller flow volumes in proportion to auger diameters.

The result is a clean hole with less loose soil and debris. For higher capacity drilling, the Series 24 operates in a 15 to 25 gpm hydraulic flow range and delivers a maximum drilling torque of 2,018 ft-lb at 2,500 psi.

General Equipment Company’s 671 DIG-R-TACH series uses a drilling industry standard two-inch hexagon auger drive system. This design eliminates excessive auger driveshaft wear. A complete line of earth augers up to 36 inches in diameter is available with Pengo-type, cast-steel boring heads and forged teeth.